12
WARNING - The heater must be properly installed before it is
used.
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR
ARC FLASH:
Apply appropriate personal protective equipment (PPE)
and follow safe electrical work practices. See NFPA 70.
A circuit breaker must be installed and serviced only by
qualified electrical personnel.
Always use a properly rated voltage sensing device to
confirm power is off.
The switch on the heater is to start the Fan and Heater.
Use the circuit breaker as power ON/OFF for the
heater. The circuit breaker is to be installed by a
certified/licensed electrician and should be located in
line of sight from the heater location or should be
capable of being locked in open position. Follow the
operating instructions to reduce the risk of fire,
electric shock, injury, or death to persons.
How to select INSIDE/WALL thermostat?
Identify the ON/OFF switch and the thermostat rocker switch
located on the rear of the heater.
You can select Inside or Wall Thermostat to control the heater
temperature by using ON/OFF and thermostat rocker switches.
To Next Page
Loading...
