5
WARNING: All wiring must be installed by a certified/licensed
electrician.
The heater must be grounded in accordance with applicable
national and local building codes.
All wiring procedures and connections should be in
accordance with applicable national and local codes.
Before installation:
Disconnect the main supply connection.
Supply cables should be 6 AWG (13.3 mm
2
) copper wires.
The heater must be connected to an individual branch circuit
protected by a 60 Amp circuit breaker only.
Supply cables must be equipped with a dual pole circuit breaker
rating at least 240V 60A/pole as main cut-off switch of power to the
heater.
Wiring compartment for accommodating supply cables and pigtail
leads are adequate and measured free space of 2524.67 cm
3
.
CAUTION: HIGH TEMPERATURE, RISK OF FIRE. Keep
electrical cords, drapery, furnishings, and other combustibles at
least 3 feet (0.9 m) from the front of the heater and away from the
sides and rear.
WARNING: To reduce the risk of fire, do not store or use gasoline
or other flammable vapors and liquids in the vicinity of the heater.
INSTALLATION INSTRUCTIONS:
1. This heater should be installed at least 6 feet (1.8 m) from the
floor. This minimum distance must be maintained.
2. Do not install closer than 1 foot (0.3 m) from any adjacent
surfaces or walls.
3. Keep at least 1 foot (0.3 m) from the back wall, regardless of
whether the wall mount bracket is used.
To Next Page
Loading...
