Dräger Oxylog 2000 - Care; Stripping down

17
Care
Stripping down
21
3
5
4
6
Care
– Clean breathing valve and ventilation hoses each time
after use.
– Clean ventilator and medical gas hoses if heavily
soiled.
Stripping down
● Remove Oxylog 2000 from holder.
1 Disconnect ventilation hose from socket.
2 Disconnect flow measuring hoses from sockets.
3 Unscrew medical gas hose from Oxylog 2000.
● When disconnecting hoses, always grip the sleeve
and not the corrugations!
If this is not done, the corrugations or hose may be
torn from the sleeve.
5 Carefully detach flow measuring hoses from flow
sensor, pulling in the axial direction of the hose nozzles.
6 Detach angled connector from flow sensor.
● Do not allow any objects to enter the flow sensor.
Do not purge with compressed air. The wind vane
inside may be damaged and cause measuring
errors!
● Detach ventilation hose from breathing valve.
015290330162903301729033
4 Disconnect flow sensor from breathing valve – do
not twist or use force on the hose nozzles, as
this can damage the flow sensor.