Dräger Oxylog 2000 - Manual

Drager Medizintechnik
Drager
Contents
General Information About the Drager Service Mode SW 2.xx 3
Definition of the Original Status .3
Calibration Functions.4
Reaction in the Event of a Technical Error (TE) .4
Error Messages During a Specific Test.5
Power Supply Low.5
Pressure Low.5
Pressure High .5
Mode Switch Position (AirMix/NoAirMix) .5
Mode Switch Position (IPPV, SIPPV/SIMV, CPAP)
(for Software Versions 3.xx and higher).6
Software Version 3.xx is Incompatible with Hardware.6
Tests in the DragerService Mode .7
Starting/Exiting the Customer Service Mode (CSM) 8
Test 001: Adjusting the Language .9
Test 002: Testing the Gas Supply.11
Test 003: Position of the Pneumatic Switch (IPPV, SIPPV/SIMV, CPAP; AirMix/NoAirMix) 12
Test 004: Buzzer Test, LED Test, and LCD Test .13
Test 005: Adjusting and Reading Out the
Potentiometers Freq., VT, TI:TE, and Pmax.14
Starting / Exiting the Extended Service Mode (ESM) 15
Test 011: Calibrating the Pressure Sensors P-Supply
P-AIRMIX and P-LA.16
Test 012: Calibrating the Minute Volume Valve in No Air Mix .18
Software Version 2.xx.19
Software Version 3.xx.20
Test 013: Calibrating the Minute Volume Valve in Air Mix.21
5503.160 Oxylog 2000 11/97 Page 1