Dräger Oxylog 2000 - Warranty Information

For
internal
use
only.
Copyright
reserved.
Drager Medizintechnik
Drager
1.4 Error Messages During a Specific Test
If the system detects and displays an error, you must confirm this error by pressing the Info
key and the Reset key simultaneously. Once the error has been removed, specific tests can
be selected and carried out again.
All potential errors and their causes are listed below:
1.4.1 Power Supply Low
Problem:
battery empty
No external power supply connected. The internal
power supply is no longer sufficient for safe
operation.
1.4.2 P ressure Low
Problem:
pressure low
Gas supply pressure is too low.
1.4.3 P ressure High
Problem:
pressure high
A gas supply source is connected although no
pressure is required for this test.
1.4.4 M o de Switch Position (AirMix/NoAirMix)
Problem:
NoAirMix !
The mode switch is not in the correct position.
or
Problem:
AirMix
The mode switch is not in the correct position.
DS-Modus 5503.160 Oxylog 2000 11/97 Service-Mode SW 2.xx
Page 5