Need help?Do you have a question about the Dräger Pac 6000 and is the answer not in the manual?
General| Measurement Principle | Electrochemical sensor |
|---|---|
| Operating Humidity | 10 to 95% RH, non-condensing |
| Ingress Protection | IP68 |
| Gas Detected | O2 |
| Resolution | CO: 1 ppm; H₂S: 0.1 ppm; O₂: 0.1 vol.% |
| Response Time | <15 seconds (O2) |
| Alarm Indicators | Visual, audible, and vibration alarms |
| Data Logging | No |
| Dimensions | 64 x 84 x 20 mm |
| Certifications | CE, ATEX, IECEx |
General safety guidelines for using the Dräger Pac 6x00/8x00 gas detector.
Precautions and warnings regarding the use of the gas detector in explosion-hazard areas.
Steps and procedures for preparing the gas detector before use.
Guidelines and warnings for operating the gas detector during use.
Steps to access the password-protected maintenance menu for calibration.
Procedure for performing a fresh air (zero point) calibration of the gas detector.
Procedure for performing a span calibration using a test gas.
Procedure and warnings for replacing the sensor in the gas detector.
Procedure and safety warnings for replacing the battery in the gas detector.
To Next Page