www.dragino.com
LSE01 LoRaWAN Soil Moisture & EC Sensor User Manual 23 / 30
3. Using the AT Commands
3.1 Access AT Commands
LSE01 supports AT Command set in the stock firmware. You can use a USB to TTL adapter to
connect to LSE01 for using AT command, as below.
Or if you have below board, use below connection:
In the PC, you need to set the serial baud rate to 9600 to access the serial console for LSE01.
LSE01 will output system info once power on as below:
To Next Page
Loading...
