NOTE: Before attempting to operate the bandsaw, it
must be securely mounted to a suitable bench or
bandsaw stand.
FASTENING TO WORK BENCH (fixings not
supplied). (Fig.8.):
To ensure sufficient upright stability of the machine it
should be bolted to a bench, table, or mounted on a
Draper bandsaw stand.
Optional accessories
Stock No. 76251 [stand for BS250A];
Stock No. 76252 [stand for BS315];
Stock No. 76256 [wheel kit for stand 76252].
Holes are provided in the machine’s base plate for this
purpose .
WARNING: The supporting surface where the bandsaw
is mounted should be examined carefully after
mounting to ensure that no movement during use can
result. If any tipping or walking is noted, secure the
workbench or supporting surface before operating the
bandsaw.
FIG.8
ASSEMBLY
RIP FENCE (Fig7.):
The rip fence can be used on both sides of the saw
band; however Stock No. 76237 the fence will need
swapping to the opposite side of the main body. Slide
the rip fence main body into the graduated scale.
Stock No. 76236; lock lever ,to secure the fence.
Stock No. 76237; tighten locking knob -.
,
-
- 10 -
To Next Page
Loading...
