OPERATION & USE
- 13 -
BASIC SAW OPERATIONS
WARNING
FOR YOUR OWN SAFETY, READ AND UNDERSTAND
ALL SAFETY INSTRUCTIONS AND OPERATING
PROCEDURES THROUGHOUT THE MANUAL BEFORE
USING THIS MACHINE.
BODY AND HAND POSITION
Proper positioning of your body and hands when
operating the mitre saw will make cutting easier and
safer. Never place hands near cutting area. Place hand
at least 4" from path of blade. Hold workpiece firmly
to the fence to prevent movement towards the blade.
Keep hands in position until trigger has been
released and the blade has completely stopped.
Before making a cut, make a “dry run” with the power
off so you can see the path of the blade (Fig.22).
WARNING
DO NOT TRY TO CUT SHORT PIECES,YOU CANNOT
PROPERLY SUPPORT THE WORKPIECE AND HOLD
DOWN THE WORKPIECE BY HAND AND KEEP YOUR
HAND THE REQUIRED DISTANCE FROM THE BLADE.
MITRE CUT
When a mitre cut is required, move the saw to the
desired angle. Do not stand in front of the saw table.
Move with the handle to the mitre angle to make the
cut (Fig.23).
NOTE: Remember to loosen the fence locking
handles before changing the mitre angle
with the fence in the rear position.
Fig.22.
Fig.23.
To Next Page
Loading...
