Draytek Vigor130 Series - Page 243

Vigor130 Series User’s Guide
233
-p <ratio>
It means to enable bandwidth limit ratio for UDP.
-t <mode>
It means to enable/disable Outbound TCP ACK Prioritize.
0: disable
1: enable
-V
Show all the settings.
-D
Set all to factory default (for all WANs).
[…]
It means that you can type in several commands in one line.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> qos setup -m 3 -i 9500 -o 8500 -r 3:20 -u 1 -p 50 -t 1
WAN1 QOS mode is both
Wan 1 is XDSL model ,don,t need to set up
Wan 1 is XDSL model ,don,t need to set up
WAN1 class 3 ratio set to 20
WAN1 udp bandwidth control set to enable
WAN1 udp bandwidth limit ratio set to 50
WAN1 Outbound TCP ACK Prioritizel set to enable
QoS WAN1 set complete; restart QoS
>