17
Canceling Modulations
An easy way to cancel all modulation destinations for a given modulation source is to:
1) Press the MENU button,
2) Select the mod source with the rotary selector, and then
3) Press and hold the MENU button for one second.
4) The MENU button light will go out, and any mod destinations for that mod source are now reset or turned
off (see the MENU MAP for more details on this).
Modulation Behavior
An important point to note is when modulating a parameter, with the exception of the LFO’s, the modulation
amount from the source is added to the current destination parameter setting. For example, if the programmed
amplitude of the oscillator is already maximum (the LVL setting), then you can’t use the modulation wheel (MOD
W) to increase the value anymore. It is already at its maximum. You would rst need to reduce the oscillator
level setting (LVL), so using the modulation wheel would have room to add value to the parameter and control
the increase in amplitude.
For LFO2 though, modulations will be added in a mixing method. That means that the slider value sets the
starting point and then LFO 2 is mixed in there. If LFO2 amount is at max, the slider value will have no effect.
We strongly suggest you to experiment with modulations and the way they are added, especially with LFO2, as
we consider it on of the strongest morphing points that Nymphes has to offer.
To Next Page
Loading...
