14 15
EN EN
Dust Bin
Routine Maintenance
1. Open the robot cover and press the dust bin clip to remove the dust bin.
2. Open the bin cover and empty the bin as shown in the diagram.
* Clean it as needed
Note: The cleaning tool can be used to empty the dust bin.
Filter
1. Remove the lter and gently tap the lter frame to shake out the dirt.
Note: Do not attempt to clean the lter with a brush, nger, or sharp object.
2. If necessary, rinse the dust bin and the lter under the running water and
dry them completely before re-installing.
Note:
· Only rinse the dust bin and the lter with clean water. Do not use any soap or detergent.
· Use the dust bin and lter only when whey are completely dry.
* Clean it once every 2 weeks (fully dry after cleaning) and change it every 3 months
How to Use
Functions in the App
1. Map management
The homepage of the app displays the current map. On this page, "No-Go
Zone" allows you to set zones to be avoided. "Map Management" allows you
to modify the current map.
For optimal performance, follow the instructions below to clean and maintain
the robot and base.
2. Cleaning mode settings
"Cleaning Mode" on the homepage allows you to change the cleaning mode,
the suction power, and the dampness of the mop pads.
3. Self-cleaning settings
"Self-Cleaning Settings" on the homepage allows you to change the
frequency of self-cleaning, manually start a mop pad cleaning task, or
manually start or stop a mop pad drying task.
4. Product settings
The "Settings" page allows you to enable or disable device functions, congure
scheduled cleanup, or view cleaning history and device information.
Note:
· A map must be created before you can use the room-based or zone-based
cleaning function or manage the maps.
· For more information about functions, check the corresponding interfaces or
guides in the app.
· The app you use may be an updated version, please follow the instructions based
on the current app version.
Routine Maintenance
Parts
Note: The replacement frequency will depend on your usage of the robot. If an
exception occurs due to special circumstances, the parts should be replaced.
Part Maintenance Frequency Replacement Frequency
Waste Tank After each use /
Dust Bin Filter
Once every 2 weeks
Every 3 to 6 months
Fresh Tank
/
Fresh Tank Filter Media
Washboard
Main Brush/ Side Brush
3D ToF Sensor/ AI Visual Sensor
Mop Pad
Once every month
Every 1 to 3 months
Dust Bin
/
Bottom of the Robot
Cli Sensors
Universal Wheel/ Auxiliary
Wheel
Charging Contacts on Robot
Signaling Area on Base
Overow Sensors on Base
Charging Contacts on Base
Body of the Base
Side Brush
/
Every 3 to 6 months
Main Brush Every 6 to 12 months
To Next Page
Loading...
Need help?
General
