8 9
EN EN
>1.5 m
>
5
c
m
>
5
c
m
PREP Your Home
Remove power cords, slippers, and hard objects that may collide with the
robot to improve work eciency.
Open the door of the room to be cleaned, and put the furniture in its proper
place to leave more space.
Before cleaning, place a physical barrier at the edge of the stairs and sofa
to ensure the secure and smooth operations of the robot.
The robot can recognize objects with an AI Visual sensor. To keep the
optimal recognition performance, make sure all areas to be cleaned are
well illuminated.
Note: When operating the robot for the rst time, follow it around while cleaning to remove any potential obstacles in time.
To prevent the robot from not recognizing areas that need to be cleaned, do not stand in front of the robot, threshold, hallway, or narrow places.
1. Remove the protective strips
2. Install the side brush
Before Use
3. Place the base against the wall and charge the robot
Click
Install the side brush
until it clicks into place.
Within the Good Wi-Fi
Range
Note:
·
Remove any objects that are closer than 1.5 m from the front and 5 cm from either
side of the base.
·
Make sure that no objects might block the signaling area.
·
To prevent water stains from wetting wood oors or carpets, placing the base on
tile or marble oors is recommended.
· Install the base in a location that is as open as possible with a good Wi-Fi signal.
· Insert the power cord into the base and plug it into the socket.
· Place the robot onto the base, and the robot will trun on
automatically and start charging.
· Fully charging the robot before the rst use is recommended. After the robot
is fully charged, the status indicator will illuminate white for 10 minutes and
will then dim.
To Next Page
Loading...
Need help?
General
