Dreame H12 User Manual

12
EN
Care & Maintenance
One-Touch Self-Cleaning
1. After the vacuum completes the cleaning task,
place it back onto the base and make sure that
the water in the clean water tank is sucient for
self-cleaning.
2. Briey press the self-cleaning button on the top
of the handle, the self-cleaning indicator will
light up, and the vacuum will start self-cleaning.
3. After the self-cleaning ends, the vacuum
continues charging its battery.
* The self-cleaning function can be enabled only when the vacuum is being charged and the battery
level is more than 15%.
Tips:
1. Turn o the vacuum before care and maintenance.
2. Replace parts if needed. The parts must be replaced by those available from the
manufacturer or its service agent.
3. If the vacuum is not used for an extended period, fully charge it, unplug the power
adapter, and store the vacuum in a cool, low-humidity environment away from direct
sunlight. To avoid over-discharge of the battery, charge the vacuum at least once
every 3 months.
Note: After the vacuum completes self-cleaning, clean theusedwater tankpromptly. If some stains
are left on the charging base, clean the base.

Dreame H12 Specifications

General

Type	Wet and Dry Vacuum Cleaner
Battery Capacity	4000 mAh
Rated Power	200W
Run Time	35 minutes
Clean Water Tank Capacity	900 ml
Dirty Water Tank Capacity	500 ml
Dust Tank Capacity	Not applicable
Self-Cleaning	Yes
Display	LED
Cordless	Yes
Wet and Dry Cleaning	Yes
Cleaning Modes	Auto
Charging Time	Approx. 5 hours