20 21
EN EN
Routine Maintenance
Note:
The float ball in the used water tank is a movable part. Do not
apply too much force when cleaning it to avoid damaging it.
Used Water Tank
1. Remove the used water tank, open its cover and pour out the used water.
2. Rinse the used water tank with clean water, and use the provided
cleaning tool to clean the inner wall of the used water tank.
Main Brush
1. Press the brush guard clips inwards to remove the brush guard and
lift the brush out of the robot.
2. Pull out the brush covers at both ends of the brush as shown in the
figure. Use the provided cleaning tool to remove any hair tangled in the
brush. Reinstall the brush covers on both ends of the brush, and then
reinstall the brush. Press on the brush guard to lock it in place.
①
②
Routine Maintenance
Dust Bag
2. Discard the dust bag.
1. Unlock the dust tank cover and then remove it.
3. Remove the dust and debris from the filter with a dry cloth.
Note:
Pulling outwards on the handle will seal the dust bag to prevent
the dust and debris from accidentally falling out.
4. Install a new dust bag. Then install back the dust tank cover and lock it.
② ①
To Next Page
Loading...
