② Use scissors to pick up the tangled hair and fibers from the comb
and cut off. Wipe the dust inside the slot and cover plate with dry
cloth or paper towel, and fully dry it before installation and use.
③ You can rinse the comb with water if it is too dirty to clean.
④ Place the comb vertically and dry for at least 24 hours before use.
Operation
22. What should I do if the vacuum stop working?
Refer to the error alert displayed on the screen and take
corresponding measures.
① Airduct Clogged: check if the dust cup, extension rod, or roller
brush mounting hold is clogged.
② Clean Comb: clean the fibers and hair tangled on the comb.
③ Battery Run Down: charge the vacuum as soon as possible.
④ Battery Overheating: wait for the battery to cool down before use.
⑤ Error: contact aftersales@dreame.tech for repairing.
To Next Page
Loading...
