Accessories
16. How to install the T20 vacuum?
① Connect the main brush with extension rod
When connecting, hold the main brush, insert the mounting hole
under the extension rod into the soft roller brush vertically, and align
the conductive pin until you hear a "click" sound, indicating the
installation is finished.
② Connect the extension rod with main body
Align the conductive pin of extension rod with the main body mount
adaptor, push up until you hear a click sound, indicating it is properly
locked.
③ Installation and use of water tank(For Japan, Korea, Chinese
Taiwan)
a. Wet the mop and wring it out until it does not drip, and stick it
firmly on the bottom of the water tank
b. Open the water tank plug, slowly inject an appropriate amount of
water, and close the water tank plug
To Next Page
Loading...
