4 5
Product Overview
Accessories
Extension Rod
Charger Crevice NozzleExtension Hose 2-in-1 Brush Nozzle
Smart Multi-brush Bar Mini Electric Brush2-in-1 Charging &
Storage Mount
(Including screws ×2, wall plugs
×2, mounting template sticker )
Note: The illustrations in this manual are indicative only. The actual product may dier.
Introduction of Display Screen
Electronic Lock/Reset Filter
• Press briey to enter/exit lock
• Press and hold for 1.5 seconds to
enter the lter reset interface
Suction Level Status
Lock Status
Switching Suction Level
• Press briey to switch the suction
levels
Setting Language
Switching Suction Level
Note: If the vacuum cleaner cannot work normally, the display will show an error message.
Please refer to the troubleshooting part to nd your solution.
Note: The display screen will turn to the main page if there is no operation for more than 15
seconds.
Note:
• Stop the vacuum cleaner at any time while cleaning. Then it will continue to use the last
selected suction level when started again.
• Connecting the smart multi-brush bar to the vacuum cleaner will activate the Auto
Mode. In this mode, the vacuum cleaner can automatically adjust its suction level
depending on the surface type.
Press and hold the button for 3 seconds to open the language list, then press the button
to scroll through the language to select the desired one. Press and hold the button
for 3 seconds to use the selected language.
Press the button to switch between three suction levels of eco, med/auto, and turbo.
The corresponding suction level will be highlighted on the display screen.
Only when using the smart multi-brush bar, the auto mode will be activated and the
notication of "Auto" will appear on the display screen. The vacuum cleaner will then
automatically switch the suction level between the oor/tile and the carpet.
Product Overview
To Next Page
Loading...
Need help?
General
Weight and Dimensions
