Clean Robot Sensors and Charging Contacts
Wipe sensors and charging contacts of the robot by using a soft and dry cloth, as shown in the below figure:
Routine Maintenance
Note: A wet cloth can damage sensitive elements within the robot and the charging dock. Please use a dry cloth for cleaning.
Battery
The robot contains a high-performance lithium-ion battery pack. Make sure
that the battery remains well-charged for daily use to maintain optimal
battery performance. If the robot is not used for an extended period of time,
charge the robot at least once every three months.
Charging Contacts
Charging Contact
Charging Contact
Edge Sensor
Bumper
Infrared Deceleration Sensor
EN
18
To Next Page
Loading...
