Dremel 3D45 Original Instructions

objects created by Dremel 3D45 may result in
property damage and personal injury.
o. Do not modify Dremel 3D45 or alter factory
Modications may result in equipment
and property damage, and personal injury.
p. 
Dremel 3D45 may
become damaged. Dremel 3D45 is intended to
operate in temperature between 16-29° C
(60 - 85° F).
 
The object may build
incorrectly.
r. 

Changing the lament during building will
cancel the object and may damage the extruder.
s. 
Doing so may damage the
extruder.
t. 
Dremel 3D45 will not work
properly with damaged extruder tip and will require
replacement.
 

Use of improper glue may result in equipment
damage and poor object build quality.
 

platform. Sudden tool slip and improper body
position during object removal from the build
platform may result in personal injury.
w. 
Scratches in the build platform
will result in improper object creation.
x. Tempered glass
plate may break and result in personal injury.
y. 
plastic holder. Contact with tempered glass plate
edge may result in personal injury.
 
Tempered glass plate may
separate from plastic holder and result in personal
injury.
aa. 

3D45. Structural models created by inexperienced
designers may result in property damage and
personal injury.
SERVICE
a. 

Failure to do so may result in personal injury and
equipment damage.
b. 

Dremel replacement parts. This will ensure that
proper operation and safety of Dremel 3D45 is
maintained.
c. 
components. Use of lament, or 3D objects other
than Dremel
®
approved lament and genuine
Dremel
®
components may void warranty.
TABLE OF CONTENTS
 ......................................2
Table of contents...................................................3
Used symbols ........................................................ 4
 ...................4
..................4
 ........4
 ....................................................5
Glossary of Terms ................................................. 6
 .................................. 
 ............................................................9
Kit Contents*..........................................................9
 ....................................................... 11
 ............................................16
 .......................................................... 
 .............................
 .......................................19
 ................................................................24
 ........................................
Best Practices .....................................................
Maintenance ......................................................... 
 ...................................30
 ..................32
Dremel
®
................33
3

Dremel 3D45 Specifications

General

Layer Resolution	50 - 300 microns
Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Max Extruder Temperature	280 °C
Max Bed Temperature	100 °C
Technology	Fused Filament Fabrication (FFF)
Heated Bed	Yes
Print Speed	Up to 150 mm/s
Enclosed Print Chamber	Yes
Connectivity	USB, Wi-Fi, Ethernet
Supported Filaments	PLA, Nylon, PETG, ECO-ABS
Printer Dimensions	515 x 406 x 403 mm
Display	Full-color touchscreen
Power Requirements	100 - 240 V, 50/60 Hz