FIRMWARE & OPEN SOURCE SOFTWARE
Firmware Updates
throughout the life of the product. There are two ways of updating the Dremel 3D45: (1) Download update from
dremel3d.com and install using USB memory drive. (2) Connect the Dremel 3D45 to the internet and update from
the Dremel 3D45 touch screen.
This product contains software components that are licensed by the holder of the rights under any version of
the GNU General Public License (GPL), GNU Lesser General Public License (LGPL) or any other open source
software license which requires that source code be made available. You can receive a complete machine-readable
copy of the corresponding source code by sending a written request to:
Dremel
Racine, WI USA 53408-1126
Your request should include: (i) the name of the Dremel product, (ii) the serial number (if applicable), (iii) the
software version (if applicable), (iv) your name, (v) your company name (if applicable) and (vi) your return mailing
and email address (if available).
We may charge you a nominal fee to cover the cost of the physical media and distribution.
You may send your request (i) within three (3) years of the date you received the product that included the software
which is subject of your request or (ii) in the case of code licensed under the GPL version 3 for as long as Dremel
offers spare parts or customer support for that product.
Warranty regarding further use of the Open Source Software:
DREMEL provides no warranty for the Open Source Software programs contained in this device, if such programs
have no warranty claims against DREMEL in the event that the Open Source Software infringes the intellectual
32
To Next Page
