Need help?Do you have a question about the Dremel 3D20 and is the answer not in the manual?
General| Layer Resolution | 100 microns |
|---|---|
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm |
| Print Technology | Fused Filament Fabrication (FFF) |
| Connectivity | USB |
| Supported Filament Types | PLA |
| Software | Dremel DigiLab 3D Slicer |
| Display | LCD |
| Operating System Compatibility | Windows, Mac |
| Power Requirements | 100-240V, 50/60Hz |
To Next Page
