Dremel 3D20 - Unpacking Procedure; Opening the Box and Accessing Contents; Removing the Printer from Packaging

UNPACKING
1. Place box on table and cut tape.
2. Lift outer box and allow inner box to open.
3. Remove carton lid from top of your Dremel 3D20
4. Rectangular carton on top of your Dremel 3D20
contains product manual, quick-start guide, and
set-up pieces. Remove the kit contents located
inside.
5. Using a rm grip, lift your Dremel 3D20 out of
packaging and place gently on stable work surface.
6. Remove plastic lid from top of your Dremel 3D20.
7. Remove tape from your Dremel 3D20 door.
8. Remove inserts from inside of your Dremel 3D20.
Tip: Keep packaging for future transportation
and storage.
10