14
Two person lift
required.
Lifting the
laser cutter alone may result in personal
injury.
Create a workstation. Prepare a flat,
sturdy table or workbench that can
support the weight of the LC40 and Hex
Box™. The workstation should be close to
an electrical outlet and allow for
necessary ventilation described in the
SETUP section "Exhaust Management"
page 24.
Open the top of the box.
1. Remove Reusable Tote Bag from
packaging and pull out box 1. Open Lid
to reveal the project sample material
and the Honeycomb Plate.
2. Remove Instructional Manual, Water
Hoses, Air Tube, Screws, Hex Box™
Cap, Hex Keys, Spacer Puck from box 2.
3. Remove foam to reveal the Dremel
LC40 Laser Cutter. Use two people to
lift Dremel LC40 Laser Cutter out of
box by straps and place on
workstation. After the Dremel LC40
Laser Cutter has been taken out of the
box, hook straps to the Reusable Tote
Bag. DO NOT CUT STRAPS.
4. Open the Lid of the Dremel LC40
Laser Cutter to reveal box 3 with Hex
Box™, Exhaust Duct, and Exhaust
Shroud.
Note: Save the Dremel LC40 packaging
for future transport and storage.
UNPACKING
To Next Page
Loading...
Need help?
General
