The LC40 Touch Screen allows control
of the basic functions of the laser
without the need to connect to a
computer.
Status Bar — Displays information
about selected conditions of the LC40.
Menu Bar — Displays the icons and
names of the Touch Screen menus.
Control Interface — Information or
additional action pertaining to selected
menu item.
IP Address — A unique number used to
connect the Dremel LC40 Laser Cutter
over a network to a web browser.
Firmware Version — Displays the
currently installed firmware version.
Observe all provided warnings and safety instructions prior to and
when using the Dremel LC40 Laser Cutter. Failure to do so may
result in fire, equipment damage, property damage and/or personal injury, up to and
including death.
Do not tap or scratch LCD screen with sharp objects. The LCD
screen may become damaged.
To Next Page
Loading...
Need help?
General
