Dremel DIGILAB LC40 - LCD TOUCH SCREEN (continued); HOME Screen - Locked State and Job History

22
Connect the Air Tube to the fittings on the
Dremel LC40 Laser Cutter and the Hex
Box™. There are labels on the Dremel LC40
Laser Cutter and the Hex Box™ to help
identify the correct fittings. Fig. 10 & 11.
Attach Air Tube
AIR TUBE
TUYAU À AIR
TUBO DE AIRE
WATER IN
ENTRÉE D’EAU
ENTRADA DE AGUA
WATER OUT
SORTIE D’EAU
SALIDA DE AGUA
Hex Box
12V
Air Tube
AIR
TUBE
TUY
AU À
AIR
TUBO DE AIRE
Hex B
ox
12V
Air Tube
SETUP
Air Tube
Fitting
Air Tube
Fitting
Fig. 10 — Rear of Dremel LC40 Laser Cutter
Fig. 11 — Rear of Hex Box™
Push the ends of the tubing onto the
fittings until they are snug.
Correct Incorrect
DM 1600A01CX8 08-18 LC40 EN.qxp_LC40 8/17/18 10:32 AM Page 22