43
deutschenglishfrançaisespañolitaliano
43
9.6 Exceeding of entered heating/cooling times
After elapse of times adjusted regu-
larly (display position a/c) there will be
an acoustic signal. The exceeded time
will be blinking in the display as control
mechanism.
9.7 Entering a wrong barcode
If a barcode is scanned that does not
correspond to the programming of the
Drufomat scan, four acoustic warning
signals will be heard and the display will
show ERROR at position b.
By scanning the correct barcode you
can proceed further, as described in
point 8.0.
To Next Page
Loading...