What to do if the compressor will not start on my Dri-Eaz Evolution 115v?
If your Dri-Eaz Dehumidifier's compressor won't start, switch off the unit and wait 5 minutes before restarting it. If that doesn't work, try reducing the room temperature to below 90° F (32° C).
What to do if the blower wheel is not turning on my Dri-Eaz Dehumidifier?
If the blower wheel in your Dri-Eaz Dehumidifier isn't turning, check for any obstructions and remove them. Also, check the blower wheel set screw and tighten it if it's loose.
What to do if the pump does not function on my Dri-Eaz Evolution 115v?
If the pump on your Dri-Eaz Dehumidifier isn't working, try cleaning the float valve shaft, as a stuck float valve may be the cause.
Why is my Dri-Eaz Dehumidifier running but the room is not dry?
If your Dri-Eaz Dehumidifier is running but the room isn't drying, give it more time to dry the area. You can also improve air movement in the room by using TurboDryers and reduce excessive airflow into the drying area.
Why is my Dri-Eaz Evolution 115v collecting little water?
If your Dri-Eaz Dehumidifier is collecting very little water, first check the room's humidity with a hygrometer to ensure the air isn't already dry. Also, ensure the room temperature is adequate, and check the unit's filter and coils for any obstructions, cleaning them if necessary.
Why is my Dri-Eaz Evolution 115v Dehumidifier continuously in defrost?
If your Dri-Eaz Dehumidifier is continuously in defrost mode, the room temperature may be too low. Try increasing the room temperature.
Explains how the dehumidifier reduces humidity in enclosed spaces and its benefits.
Describes the refrigerant dehumidifier's operation including evaporator core and defrost cycle.
Advises operating in enclosed spaces and minimizing traffic for efficiency.
Guides placement in the middle of a room away from walls for optimal airflow.
Instructions for setting the unit upright after transport to allow oil to return to the compressor.
Details on releasing and locking the unit's handle using a red lever.
Explains how to connect and detach the drainage hose for water removal.
Instructions for connecting the unit to a standard 115-volt grounded outlet.
Describes how to turn the unit on and off, including compressor delay indicators.
Explains how to stop the display cycle at specific messages or restart the cycle.
Step-by-step guide to change the display language using the DISPLAY and CLEAR keys.
Instructions on how to reset the JOB HOURS reading to zero.
Checks for electrical cord damage and filter inspection for dust and dirt.
Procedures for cleaning coils, catch basin, drain hose, and filter cover.
Guidance on inspecting the pump system, including service center contact.
Covers problems like unit not operating, compressor not starting, and blower not turning.
Addresses issues such as poor drying, continuous defrost, and little water collection.
Solutions for when the unit's water pump does not function.
Details model, type, operating range, water removal, and compressor type.
Provides height, width, depth, weight, control types, and cord length.
General| Power Supply | 115V |
|---|---|
| Refrigerant | R410A |
| Model | Evolution |
| Operating Temperature Range | 33°F to 100°F |
| Water Removal Capacity (AHAM) | 10 gallons per day |
To Next Page