ww w.drilldoctor.com28
Drill Doctor
®
Maintenance
After sharpening 20 to 25 drill bits, the drill bit grinding dust will
accumulate in the grinding compartment. Grinding particles will
promote wear in the Sharpening Port and Chuck, so cleaning
on a consistent basis can add life to your machine. Before any
maintenance or cleaning is performed, be sure to disconnect your
Drill Doctor.
Removing the Wheel Access Cover
With the Drill Doctor unplugged, use your nail or the tip of your
nger pull the Wheel Access Cover. To close, insert the Cover in
the slots and snap it back into place.
Cleaning Your Drill Doctor
®
With the Drill Doctor unplugged, shake accumulated drill bit
grinding dust from behind the Wheel Cover into a disposable con-
tainer. Remove dust particles around the wheel with a small, dry
brush. Dispose of the container and drill bit dust in a safe and en-
vironmentally approved manner. With a dry cloth wipe the inside
and outside of the Sharpening Port to remove any grinding dust
that may have accumulated. A standard 1” vacuum hose works
equally well.
Cleaning the Chuck
Brush out with a small, dry brush.
To Next Page
Loading...
