43
Module Programming
[801] PC5400 Printer Module Programming
Please refer to your PC5400 Installation Manual for installation and programming instructions.
[803] Alternative Communicator Programming
Please refer to your LINKS2X50 Installation Manual for installation and programming instructions.
[804] PC5132 Wireless Expansion Programming
Please refer to your PC5132 Installation Manual for programming locations and instructions.
Special Installer Functions
[901] Installer Walk Test Mode Enable / Disable (Section 5.33 “Walk Test (Installer)” on page 28)
[902] Module Supervision Reset (Section 2.7 “Removing Modules” on page 5)
[903] Module Supervision Field (Section 2.6 “Supervision” on page 5)
[904] Wireless Module Placement Test
For more information, please refer to your PC5132 Installation Manual
• Select the module / transmitter (Zones 01-32).
• Press [#] to Cancel.
Placement Led Keypad LCD Keypad Bell / Buzzer
Good Light 1 ON Steady “GOOD” 1 Beep / Squawk
Fair Light 2 ON Steady “FAIR” 2 Beeps / Squawks
Bad Light 3 ON Steady “BAD” 3 Beeps / Squawks
[990] Installer Lockout Enable
(Section 5.32 “Installer’s Lockout” on page 28)
[991] Installer Lockout Disable (Section 5.32 “Installer’s Lockout” on page 28)
[993] Restore Alternative Communicator to Factory Default Programming
(Section 5.31 “Resetting Factory Defaults” on page 27)
[996] Restore PC5132 to Factory Default Programming (Section 5.31 “Resetting Factory Defaults” on page 27)
[997] Restore PC5400 to Factory Default Programming (Section 5.31 “Resetting Factory Defaults” on page 27)
[999] Restore PC1565 to Factory Default Programming (Section 5.31 “Resetting Factory Defaults” on page 27)
To Next Page
Loading...
