12
access code assigned to a WLS Key is manually entered at a keypad.
Programming Codes
Programming codes from an LCD Keypad:
Master Code
Be sure to record your new Master Code on the “System Information” page in this booklet.
Note: We recommend that the factory default Master Code [1234] not be used.
Additional Access Codes
Press the [,] key to enter the function list. Scroll (< >) to
Press [5] or [,]. The display will read
Enter your current Master Code. The display will read
“01P” represents the first user. To program the Master Code (40),
press 40 on the keypad, or scroll to “40P” and press the [,] key.
The display will read
Enter the new Master Code. The Master Code must be four digits
unless otherwise indicated by your installer. Enter digits 0 through
9 only. Once the new code is entered, the keypad will beep 3 times
and the display will read
Press [#] to exit the code programming function.
To erase, add or change a user code, press [,] to enter the
functions list. Use the arrow (< >) keys to scroll to the following
message
Press [,]. The display will read
Enter the Master Code. The display will read...
For the code you want to change, enter the user number on the
keypad or use the scroll keys to go to“02P”to 39P”. Press the [,]
key to select the code you wish to alter. The display will read
To add or change a code, enter the new code. Access codes must
be four digits unless otherwise indicated by your installer. Enter
digits 0 through 9 only. To delete an access code, enter [,]. Once
the 4 digit code or [,] has been entered, the keypad sounder will
beep 3 times and the display will read
The “P” means the code has been programmed. If there is no “P”
then that code is deleted. Press [#] to exit the code programming
function. The Master Code cannot be erased.
Press (*) for <>
Access Codes
Enter Master
Access Code
(*) to Edit <>
User Code 01P
Enter New Code
1234
(*) to Edit <>
User Code 01P
Press <*> for <>
Access Codes
Enter Master
Access Code
[*] to Edit <>
User Code 01P
Enter New Code
1234
[*] to Edit <>
User Code 01P
To Next Page
Loading...
Need help?
General
