DSC PowerSeries PC1404 User Manual

15
To activate the door chime from an LCD Keypad:
Downloading Enable
To enable a six-hour downloading window from any system keypad, enter [] [6] [Master Code] [5].
During this time, the panel will answer incoming downloading calls. For more information, please
ask your installer.
Fire Alarm Operation
Alarm
On a fire alarm, the bell or siren will activate following the programmed cadence.
Silence
To silence the bell or siren, press the [#] key. If the alarm is silenced and the smoke detector is not
reset, the alarm will re-sound after 90 seconds.
Resetting Smoke Detectors
Once the smoke detector is reset, if it still detects smoke, the alarm sequence will re-sound as
described above. If there is no smoke, the system will return to normal.
To reset smoke detectors from an LED Keypad:
Press [][7][2].
To reset smoke detectors from an LCD Keypad:
NOTE: If you suspect that a fire alarm has been transmitted and that there is no fire condition, call
the monitoring station to avoid an unnecessary response. If a fire condition is apparent, follow your
evacuation plan immediately. If the alarm sounds at night, evacuate immediately.
User Function Commands
First disarm the system then enter [Master Code]
The command is used to gain access to the following list of Master functions of the system.
[1] Time and Date
Enter 4 digits for 24 Hour System Time (HH-MM). Valid entries are 00-23 for the hour and 00-59 for
minutes.
Enter 6 digits for the Month, Day and Year (MM-DD-YY)
[2] Auto-arm Control
Pressing [2] while in the User Function menu will enable (3 beeps) or disable (one long beep) the
Auto-arm feature. With this feature enabled, the panel will automatically arm in the Away mode
(Stay Away zones active) at the same time each day. The auto-arm time is programmed with the
[][6][Master Code][3] command.
Press [] to enter the function list, then scroll to find
Press [] or [4] to enable or disable the Door Chime feature. Press
[#] to return to the Ready state.
Press [] to enter the function list, then scroll to find
Press [] to select the output control. The display will read
Use the arrow (< >) keys to find the following message and press
the [] key to select
Press <*> for <>
Door Chime
Press <*> for <>
Output Control
Scroll to
Select Output <>
Command O/P 2
<>

DSC PowerSeries PC1404 Specifications

General

Brand	DSC
Model	PowerSeries PC1404
Category	Security System
Language	English