DSC PowerSeries PC1832

5.2 Programming Worksheets
31
[013] First System Options
[014] Second System Options
[015] Third System Options
[016] Fourth System Options
Opt Def ON OFF
1
R
Normally Closed Loops
9
R
End-of-line Resistors
2
R
Double End-of-line Resistors
9
R
Single End-of-line Resistors
3
9
R
Panel shows all Troubles when armed
R
Panel shows only Fire Troubles when armed
4
R
Tampers/Faults do not show as open
9
R
Tampers/Faults show as open
5
9
R
Auto Arm Schedule in [*][6] and installers
R
Auto-arm Schedule in Installer Programming Only
6
9
R
Audible Exit Fault Enabled
R
Audible Exit Fault Disabled
7
9
R
Event Buffer Follows Swinger Shutdown
R
Event Buffer Logs Events past Shutdown
8
R
Temporal Three Fire Signal Enabled
9
R
Standard Pulsed Fire Signal
Opt Def ON OFF
1
R
Arm /Disarm Bell Squawk Enabled
9
R
Arm /Disarm Bell Squawk Disabled
2
R
Bell Squawk During Auto-arm
9
R
No Bell Squawk During Auto-arm
3
R
Bell Squawk On Exit Delay
9
R
No Bell Squawk On Exit Delay
4
R
Bell Squawk On Entry Delay
9
R
No Bell Squawk On Entry Delay
5
R
Bell Squawk On Trouble
9
R
No Bell Squawk On Trouble
6
9
R
Audible Exit with Urgency
R
Silent Exit Delay
7
R
Exit Delay Termination Enabled
9
R
Exit Delay Termination Disabled
8
R
Residential Fire Bell is Continuous
9
R
Residential Fire Bell is Cut-off
Opt Def ON OFF
1
9
R
Fire Key Enabled
R
Fire Key Disabled
2
R
Panic Key Audible (Bell / Beeps)
9
R
Panic Key Silent
3
R
Quick Exit Enabled (ON for SIA CP-01)
9
R
Quick Exit Disabled
4
9
R
Quick Arming Enabled (No Code Required)
R
Quick Arming Disabled (Code Required)
5
R
Code Required for Bypassing
9
R
NO Code Required for Bypassing
6
R
Master Code NOT Changeable (ON for SIA CP-01)
9
R
Master Code Changeable
7
9
R
TLM Enabled
R
TLM Disabled
8
R
TLM Audible (Bell) when Armed
9
R
TLM Trouble Beeps when Armed
Opt Def ON OFF
1
9
R
AC Trouble Displayed
R
AC Trouble NOT Displayed
2
R
Trouble Light Flashes if AC Fails
9
R
Trouble Light does NOT follow AC Status
3
R
Blank Keypad when Not Used
9
R
Keypad Blanking Disabled
4
R
Code required to remove Keypad Blanking
9
R
No Code Required
5
9
R
Keypad Backlighting is Enabled
R
Keypad Backlighting is Disabled
6
R
Power Save Mode Enabled
9
R
Power Save Mode Disabled
7
R
Bypass Status Displayed While Armed
9
R
Bypass Status NOT Displayed While Armed
8
R
Keypad Tampers Enabled
9
R
Keypad Tampers Disabled
WWW.DIYALARMFORUM.COM