20
Program User Codes
Change Attributes
Press [<][>]buttons to scroll to user code. Enter
[Master Code][9][xx] to enter the user code (xx = 1-16).
[1] Supervisor’s Code
[2] Duress Code
[3] Zone Bypassing
[4] Remote Access
[5]-[6] Future Use
[7] Bell/Siren Squawk Output
[8] One Time Use Code
User Commands
User Options
Event Buffer
System Test
Time and Date
System Service/DLS
User Call-up
Walk Test
Brightness Control
Buzzer Level Control
Contrast Control
Late to Open
PGM Commands
If programmed by the installer, can be used to activate
events such as opening/closing garage doors.
Installer Programming Requires a special code.
No-Entry Arming
The system will arm in Stay mode after the exit delay
expires, the entry delay is disabled.
Quick Arm/Quick Exit
Quick Arm is equivalent to entering your user code.
Quick Exit allows you to exit the premises without disarm-
ing the system.
To Next Page
Loading...
