To Next PageTo Next PageWhat does it mean when the yellow LED flashes 8 times on my DSC Security System?
If the yellow LED on your DSC Security System flashes 8 times, it indicates a receiver supervision trouble. This occurs when supervision is enabled, but the unit cannot successfully communicate with the receiver. Contact your central station for assistance.
How to fix all LEDs being off on my DSC TL260 Security System?
If all the LEDs on your DSC Security System are off, it typically indicates a power issue. Check your power connections to both the Control Panel and the Communicator module. Also, make sure the PC-LINK cable is properly attached. If you have a TL265 and it's in Power Save Mode, note that only the yellow trouble LED will function; check the AC source to the Control Panel. Alternatively, the Control Panel may be in keypad blanking; press any key on the keypad to remove blanking momentarily.
What to do if the yellow LED flashes 6 times on my DSC TL260?
If the yellow LED on your DSC Security System flashes 6 times, this indicates an Ethernet trouble. To resolve this, first check with your ISP to confirm that network service is active in your area. Ensure your Ethernet cable is securely inserted into both the RJ45 jack of the Communicator and the NID. Verify that the yellow LINK light on both the Communicator and the NID are ON. If the link light is OFF on the NID, try restarting it. If the problem continues, replace the Ethernet cable. If DHCP is used, ensure that the unit has been assigned an IP address from the server. Check in Panel Sections [851] and [992] to verify a valid IP address is programmed. If not, contact your network administrator.
General| Brand | DSC |
|---|---|
| Model | TL260 |
| Category | Security System |
| Language | English |
Key instructions and warnings that must be followed during installation.
Instructions for the installer to convey to the system user regarding product safety.
Step-by-step guide for configuring the communicator remotely using DLS 5 software.
Instructions for correctly installing the Ethernet cable for the TL2603G/TL260 models.
Procedure for inserting and removing the SIM card from the communicator.
Detailed steps for installing the communicator into specific panel models.
Wiring instructions for connecting the communicator's power to the panel's terminals.
Steps to connect the communicator to the panel via the keybus.
Instructions for routing and plugging in the network cable for supported models.
Explains the yellow LED's function and coded flashes for troubleshooting.
Details the conditions and reporting codes for Panel Supervision Trouble.
Steps to reset the communicator to its factory default settings.
Information on how to update the device's firmware.
Lists trouble indications, possible causes, and solutions based on LED flashes.
Settings for configuring the communicator's Ethernet IP address.
Explains the 6-digit hexadecimal code indicating communicator status.
Details signal strength indicators, CSQ levels, and required actions.
Setting the installer code for accessing communicator programming.
Settings for configuring periodic test transmissions to receivers.
Provides diagnostic codes related to firmware update status.
Lists trouble indicators, their types, and causes.
Procedure to reset the communicator to factory default settings.
Details specific programming options and certifications for EN50131 compliance.
