8.1 Changing the DMX address
1) Press the UP-DOWN key until you reach the required DMX number. The numbers on
the display will start to flash (but the new DMX address hasn't yet been set).
2) Press ENTER to confirm your selection. The numbers on the display will stop flashing
and the projector is now controlled by the new 512 DMX number.
WARNING: if you press the UP-DOWN keys together the channels are calculated more
quickly and you get a faster selection.
The Xr7 Wash display panel shows all the functions available. Using these functions, it is
possible to change some of the parameters and to add some functions. Changing the DTS
setting can vary the functions of the appliance so that it does not respond to the DMX
512 used to control it. Carefully follow the instructions below before carrying out any
variations or selections.
NOTE: the symbol shows which key has to be pushed to obtain the function
desired.
9-DISPLAY FUNCTIONS
Up-DownMENU ENTERUp-Down
Up-Down
Up-DownMENU ENTERUp-Down
Up-Down
Up-DownMENU ENTER
Up-Down
MENU
ENTER
DOWN
UP
DMX IN
DMX OUT
DISPLAY
CURRENT
230V 50-60 Hz
~
8
PAN MOVEMENT INVERSION
To reverse horizontal direction of
the beam from left to right and vice
versa on DMX level variation.
TILT MOVEMENT INVERSION
To reverse vertical direction of the
beam from the bottom upwards and
vice versa on DMX level variation
REVERSE DISPLAY
Reverses display's reading
depending on the mounting
position (on the ground or
suspended).
ANTI-
CLOCKWISE
CLOCKWISE
UNIT PLACED
OVERHEAD
UNIT PLACED
ON GROUND
ANTI-
CLOCKWISE
CLOCKWISE
To Next Page
Loading...
Need help?
General
