The three new DMX channels are:
-Form 0-255 are displayed the programmable scenes (max 16 scenes M.001
M016)
-From 1-19 the unit runs the scene that has been saved in the units memory and it
is possible to play through the other scenes using the scene channel.
-From 20-235 the unit runs the configuration given by the received input DMX
values. With the channel scene it is possible to pass from one scene to the next
while with REC it is possible to record the selected scene.
-From 236-255 the unit runs the configuration given by the received DMX values
from the projector in that moment. It is possible to select a scene and then close
the GAME P with the REC channel.
Records the set scene with a variable between 0 and 255 (the display flashes
indicating that the scene has been recorded).
It is advised that you keep the REC channel set to 0 and to run through the 255 only
once you have decided to save the scene. If GAME P is not closed, by indicating the last
scene, in playback mode all 16 scenes will be played through even if not programmed.
You can set the PAN and TILT engines at high speed on your Xr7 Wash.
Press menu until you see SPEE.
Press ENTER and select a speed with UP-DOWN (there are 4 speeds). Confirm by
pressing ENTER.
When you use speed 4 (the highest) PAN and TILT speed is very high and your projector
may loose its path. In this case, the encoder corrects the position.
Fan speed regulation makes it possible to reduce fan noise. However, the ambient
temperature must be less than 35° C.
If the ambient temperature is too high, two thermal sensors will turn the lamp off.
In this case, you must increase the fan speed to ensure correct cooling of your XR7.
-Scene channel
-View channel:
-Recording channel (REC)
WARNING!
9.2 Pan & Tilt speed (SPEE) (default: 2)
9.3 Fan speed (FANS)( default: 6)
10- ERROR MESSAGES:
11
ERROR ENCODER PAN
ERROR ENCODER TILT
ERROR ADRESS DMX
ERROR LOADING
ERROR COLOUR SENSOR
ERROR COLOUR SENSOR
EPROM DATA
CIRCUIT/ZOOM 1
CIRCUIT/ZOOM 2
ERROR POSITIONING
ERROR POSITIONING
ERROR ALIGNMENT
ERROR INTERNAL
ERROR POSITIONING
ERROR IMPUT
OF COLOUR WHEEL
OF BEAM SHAPE EFFECTS
OF ZOOM
SENSORS OF ZOOM LENS
IN AUTO MODE
COMMUNICATION
To Next Page
Loading...
Need help?
General
