33
E
When the LAP function is set to Off in the menu, the current
“lap“ is not stored.
If the LAP function is active and the display is suddenly
switched off (Key-Off), the LAP function is switched off
automatically (even if the timer was ON, the lap in progress
is not saved).
If the lap timer is not stopped, it will roll over upon reaching
9 minutes, 59 seconds and 99 hundredths; the lap timer
starts counting from 0 (zero) and will keep running until the
function is disabled.
If however the LAP function is switched on and the memory
has not been cleared, but fewer than 30 laps have been
saved (e.g. 18 laps), the display will store any remaining laps
until the memory is full (in this case, it will store an additional
12 laps).
This function only displays lap times once; however, lap
times are saved for subsequent display in the Lap Memory
function.
fig. 25
“NORMAL” display
Press FLASH (1st time)
Press FLASH (2nd time)
Press FLASH
(from 32nd time onwards, unless times are reset)
for 10
secs.
for 3
secs.
for 10
secs.
https://www.motorcycle-manual.com/
To Next Page
Loading...
