46
E
Immobilizer override procedure
In the event of an “Immobilizer BLOCK“, you will have to
perform the “Immobilizer override procedure“ from the
instrument panel; enter the corresponding function as
described below:
Enter the menu and go to page “COD.“.
Note
This menu should be active only if there is at least one
immobilizer error.
With this page selected, the initial code is always displayed
as “00000”. If you hold pressed switch (1, fig. 10) in position
B “▼“ for 3 seconds, you will access the procedure for
entering the electronic code given on the Code Card.
fig. 34
B for 3 secs.
flash
YES
NO
CODE
OK?
flash
flash
flash
flash
flash
flash
flash
flash
flash
A
A
B 3 times
A
B 4 times
A
B 2 times
A
B 5 times
A
B 1 time
A
A
A
A
https://www.motorcycle-manual.com/
To Next Page
Loading...
