36
E
Erase DDA
This function enables you to delete the data saved on the
DDA: the DDA must be connected to the motorcycle wiring.
To delete the data, enter the menu and select the “Erase
DDA” page.
If you press switch (1, fig. 10) in position B “▼“ for 3 seconds
and the DDA is not acquiring data, the message “WAIT…” is
shown on the display for 10 seconds. After 10 seconds, the
message “ERASE OK” appears for 3 seconds, to confirm
that the data has been deleted.
If switch (1, fig. 10) is pressed in the B “▼“ position for 3
seconds while the DDA data logger is acquiring data, the data
logger memory is not erased and the display shows message
“FAIL“ for 3 seconds.
fig. 28
Press B (for 3 secs.)
MENU
for 3 secs.
for 10 secs.
for 3 secs.
YES
NO
DDA=ON
https://www.motorcycle-manual.com/
To Next Page
Loading...
