Upper gimp threading
The feed of the upper gimp is possible with a gimp guider placed in front of the needle.
The threading of the upper gimp is conducted as shown in the illustrations alongside
in
the alphabetical order of the letters:
–
Thread the gimp from the gimp roll holder
a
through gimp guide
b
.
–
Lead the gimp through the gimp guide angle
c
and between the tension discs of
the gimp pre-tensioning
d
.
–
Thread the gimp through the gimp guide
e
and the gimp guider
f
.
The assembly for round and flat gimps is available under the Order no.: 578 5101.
35
To Next Page
Loading...
