2.14 Cutting Pressure
The cutting pressure is set with screw 1:
Increase cutting pressure = turn to the right
Decrease cutting pressure = turn to the left
After each adjustment of screw 1 the cutting pressure must be checked.
Checking the cutting pressure
–
Turn the machine with the hand crank.
The cutting pressure may only be set so high that the hand crank can be turned at
the moment of cutting without exerting too much energy !
ATTENTION !
Excessive cutting pressure leads to unnecessary wear of
the cutting tools !
–
If even with this setting of the cutting pressure the cloth can still not be cleanly cut:
True the cutting block or check the sharpness of the knife blade (see Chapter 2.13).
1
58
To Next Page
Loading...
