ATTENTION !
• When installing new electrical appliances, make sure that the overall consumption of these
appliances is in keeping with the capacity of your batteries.
• Always disconnect the - terminal of the battery before the + terminal.
• Never put the two terminals of a battery into contact with conductive objects (tools, etc ...)
• When handling batteries, avoid leaking electrolytic liquid by holding them horizontally.
Wear gloves and clothing to avoid any risk of contact with the electrolyte liquid in case of
leakage.
• In the event of electrolyte splash, thoroughly rinse the contact area and consult a doctor.
The 12 V consuming appliances circuit breakers are located behind the electrical panel. They can
be wound by pressing a black lug
Fans
As an option, on the boat can be installed 12 V fans for cabins and dinette.
WARNING
Do not stop the fans manually by hands or other objects when they are moving.
DANGER !
The 220 V installation onboard is protected by a circuit breaker and equipped with a differential
block. Additional onboard accessory wiring in 220 V must be carried out by professionals with
the necessary recalibration of the general circuit breaker.
- Do not modify the electrical installation of the vessel or the relevant diagrams. Installation,
modifications and maintenance should be performed by a qualified electrician. Check the
system at least every 2 years
- Disconnect the ship power connectors when the system is not in use.
To Next Page
Loading...
