24
DY CAT 48
Operating WC
The electric toilets are rinsed with sea water. The sea water electric pump, its filter and the supply
valve are located as shown in black water plan.
To operate the toilet:
One of the switches next to the toilets makes possible a water intake cycle and a water outlet cycle.
The second switch makes possible to carry out a rinse cycle. Close the valves after each use. For
the use and maintenance of the electric toilets, please refer to their instruction guide.
- Switch on the 12 V domestic circuit.
- Open the sea water inlet valve
- Open the waste valve of the 50 lt tank only outside harbours
- Charge a few amount of water in the WC using Charge Button (if already water in the WC
this operation is useless)
- To empty the bowl and avoid any water movement, push the Discharge button (right one on
the panel).
- Repeat these flushing / drying operations of the bowl as many times as necessary to ensure
complete evacuation of the pipes
- Close the valves after use
- _°ò
- The black water tank (50 L) is filled with the electrical WC pump.
- The contents of the bowl pours directly into the holding tank;
- Periodically check the proper functioning of the vent of each tank.
- 5 caps on deck are provided for the emptying of the tanks
To Next Page
Loading...
