Menu Operations
Introduction
This section explains how to use the base master’s menu items to perform various
functions. Please keep the following in mind:
•
Some of these menu selections may not be available depending on the configuration of
your system.
•
Some of these menu selections were already discussed in Section 2. However, Section
2 explained how to use these selections while connected to a call. This section explains
how to use these selections when your base master is NOT connected to a call.
•
These instructions refer to the system’s default settings. If your system has been con
-
figured differently, note these differences in the areas provided or in the margins.
Using the Base Master Menu
Accessing Menu Selections
To access the menu selections:
1. Press MENU.
2. Use the VOL key to scroll to the desired menu selection, then press *ANS.
Notes:
In this manual, each title is followed by the key sequence for that menu function.
Buttons and keys should be pressed in the order written. Example: For (MENU, 1)
press the MENU button, then the 1 key.
If an Error Tone Sounds When Accessing Menu Selections
The base master sounds a busy tone (six short, low pitch beeps) if it has an associated
video display and you press the MENU button when the video display is in the program
-
ming/assignment mode. The video display must be in a pending display state for you to
perform MENU functions from the base master, and vice-versa.
ProCare 6000 Operation Manual
3-1
Section
3
To Next Page