Dukane P220 - Alarm Messages

44

403-624-00 P220 Pneumatic Ultrasonic Press System USER MANUAL


hps://support.dukane.com/EasyAlarm
Alarm
Code
Alarm Message Explanation Solution
U100  
incorrect, Serial Number incorrect, Feedback
Scaling incorrect, etc.

Dukane.
U101 Bad Parameter Alarm Internal generator fault. Contact Dukane.
U102  Internal generator fault. Contact Dukane.
U103  


Dukane.
U104 Frequency Overload Fault

The generator did not obtain a frequency lock
by the end of ramp up period.






maintenance.
-
dure.

and re-inspect.


from a test.



occurrences for a properly maintained stack.
If the above steps do not resolve problem, contact
Dukane.
U106 Peak Overload Fault 

ultrasound output.

Check if one of the stack components is loose.

are set correctly.
U108 Average Overload Fault 
and has terminated the
ultrasound output.



U110   

Consult the manual for your generator
U111 Overtemperature Fault  Check for blockage of air vents on the sides of the gen-


Alarm Messages