Installation and Operation of Flexible Batch Broiler – Electric
18
C-3. Weekly Cleaning
Catalyst Guard Catalyst Assembly
Front of
Broiler
CLEANING CONSIDERATIONS
: Do not use soap, detergents,
degreasers, silicone, sodium salts, bleaches,
anti-oxidants or any other commercial cleaning
agents to clean the catalyst. Use of these
chemicals will damage the catalyst and render
it inoperable.
NOTE: Do not clean catalyst in a dishwasher or
ultrasonic cleaner. In no case should any abrasive
materialorabrasivescrubberbeusedforcleaning.
SAFETY CONSIDERATIONS
The catalytic converter (catalyst) is normally part
of a combustion system, and the general safety
practices observed with such systems should be
practiced.Thefollowingconsiderationsarespecic
tothecatalystportion.
A: Remove power: Before removing the catalyst,
disconnect power to the broiler and allow
to cool to room temperature. Remove the
catalyst guard and set aside for re-installation
after the catalyst has been cleaned.
B: Handling catalyst: Care should be taken so
that the catalyst is not dropped or damaged
in handling. If the unit is going to be handled
soon after a cooking cycle, care should be
taken to protect one’s hands from any hot
surfaces by wearing gloves designated for this
purpose.There are no moving parts or electrical
hookups associated with the catalyst, therefore
thereshouldbenodangerofashockhazardwhen
washingtheunit.Allowthecatalysttocooltoroom
temperaturebeforestartingthecleaningprocess.
C: Operation: Understand and follow the system
instructions provided with the broiler included
in the installation and operations manual. It
is very important that you make sure that the
ductsabovethe cooking appliancearecleanof
any grease, prior to the initial operation of the
appliance with the catalytic converter in place.
To Next Page
Loading...
