19
1 Insert the power cord in the electrical
outlet and turn on the power.
• Press “I” to turn on the power.
• Press “O” to turn off the power.
The folding stoppers and stacker rollers on the
folding plates will move to their initial setting
positions when the power is turned on. Wait
for a few seconds for this to complete which is
indicated by the sound of the buzzer.
2 Raise the paper set lever and place
some paper on the paper feed table.
• Loosen the fixing screws of the guide, and move
the guide slightly more than the width of the paper.
• Loosen the paper and stack sheets of paper neatly
on the paper feed table.
• Insert the paper until its front part touches the front
guide plate lightly.
3 After pressing the guide to the side of
the paper lightly, tighten the screws
to secure the guide.
• The left and right guides move in the same
direction.
Paper can be stacked to a height of
approximately 45 mm at one time. Do not
stack too many sheets paper.
4 Lower the paper set lever.
Start the various fixed folding operations for fixed paper as follows.
7. OPERATION PROCEDURES
7-1. FIXED FOLDING OF FIXED PAPER
Power switch
Paper
Fixing screw
Paper set lever
Guide
Fixing
screw
Guides
Fixing screw
Fixing screw
Guides
Paper set lever
To Next Page
Loading...
Need help?
General