44
9-1. Ł ‘ Ł g p Ł
10. USING NON-FIXED PAPER
10-1. FIXED FOLDING PROCEDURE
Start fixed folding operations for non-fixed paper according to the following procedure.
1 Press the “Number of sheets/paper
length” button and set the paper
length input mode.
• When the paper length input mode is set, the
“paper size” and “Number of sheets/paper length”
display windows will display as shown in the
figure.
Take note that when non-fixed paper is used
in modes normally used, the paper size
automatic detection function operates and the
unit will stop.
2 Next, measure the length of the paper
to be used, and input the length on
the keypad.
• Paper lengths that can be input range from
minimum 135mm to maximum 432mm.
• Use measuring instruments which are in mm.
• To input 135, press numerical button [1] [3] and
then [5].
• To input 432mm, press numerical buttons [4],[3],
and then [2].
When using paper which are 135mm to 152
mm long, the folding modes-double folding,
irregular accordion folding, brochure folding,
etc.-cannot be selected as such paper are too
big for the folding plate to fold them into these
styles.
If the paper length has already been
registered, press the “clear” button to erase
the value registered first before inputting.
To Next Page
Loading...
Need help?
General