46
10-2. SPECIAL FOLDING PROCEDURES
1 Press the “Number of sheets/paper
length” button and set the paper
length input mode.
• When the paper length input mode is set, the
“paper size” and “Number of sheets/paper length”
display windows will display as shown in the
figure.
Take note that when non-fixed paper is used
in modes normally used, the paper size
automatic detection function operates and the
unit will stop.
2 Next, measure the length of the paper
to be used, and input the length on
the keypad.
• Paper lengths that can be input range from
minimum 135mm to maximum 432mm.
• Use measuring instruments which are in mm.
If the paper length has already been
registered, press the “clear” button to erase
the value registered first before inputting.
3 Register the paper length input.
• Continue pressing the “Number of sheets/paper
length” button until the buzzer sounds.
• The “paper size” and “Number of sheets/paper
length” display windows will switch to the paper
length folding mode shown in the figure.
4 Stack some sheets of paper on the
paper feed table.
10. USING NON-FIXED PAPER
Paper
Paper set lever
To Next Page
Loading...
Need help?
General